Hello, doing a couple custom SBR builds and want to use Ruger's machined FSB/gas block instead of a normal mil-spec FSB.
Tried to get them through Ruger, but no answer after several emails, so I thought I'd try here in case anyone is removing theirs to install a low profile system. These are going on new barrels so the need to drill the slots for the taper pins on top (Ruger) vs. the bottom is not an issue.
Thanks in advance for any help.
Place for you to sell or trade your stuff with other ZS members. Please read the sticky about selling stuff before you post. Note that only paid members may post in Bartertown.
Moderator: ZS Global Moderators
1 post • Page 1 of 1
- ZS Lifetime Member
- Posts: 1890
- Joined: Sat Dec 31, 2011 8:16 am
- Favorite Zombie Movies: All of them!
- Location: Hill Country, Texas
Molon Latte...come & take our coffee order
Doctorr Fabulous wrote:... It's fun to play pretend, but this is the internet, and it's time to be serious.
zengunfighter wrote:... you don't want to blow a tranny in the middle of a pursuit...
woodsghost wrote:... A defensive gun without training is basically a talisman. It might ward off evil, but I wouldn't count on it.