Hello, doing a couple custom SBR builds and want to use Ruger's machined FSB/gas block instead of a normal mil-spec FSB.
Tried to get them through Ruger, but no answer after several emails, so I thought I'd try here in case anyone is removing theirs to install a low profile system. These are going on new barrels so the need to drill the slots for the taper pins on top (Ruger) vs. the bottom is not an issue.
Thanks in advance for any help.
...come & take our coffee order
Doctorr Fabulous wrote:
... It's fun to play pretend, but this is the internet, and it's time to be serious.
... you don't want to blow a tranny in the middle of a pursuit...
... A defensive gun without training is basically a talisman. It might ward off evil, but I wouldn't count on it.