S&W Shield EZ Recall (Nov. 2020)

Handgun, Pistol and Revolver topics
Post Reply
User avatar
RickOShea
ZS Lifetime Member
ZS Lifetime Member
Posts: 8463
Joined: Mon Jul 13, 2009 5:24 pm
Location: Gulf Coast, AL

S&W Shield EZ Recall (Nov. 2020)

Post by RickOShea » Mon Nov 23, 2020 10:41 pm

https://www.mpshieldezrecall.com/

M&P SHIELD® EZ® PISTOL IMPORTANT SAFETY RECALL NOTICE FOR PISTOLS MANUFACTURED BETWEEN MARCH 1ST, 2020 AND OCTOBER 31ST, 2020

Smith & Wesson has identified two M&P Shield EZ Pistols on which the hammers manufactured by our supplier were cracked. In those firearms, the hammer failed to fully engage the sear, causing the round to fire, cycling the slide, and potentially resulting in multiple discharges without depressing the trigger. This issue can occur in the following two scenarios:

​1. With a loaded magazine in the firearm and the grip safety depressed, releasing the slide (by pulling it back, or releasing the slide stop), may ignite the round as the slide closes, without engaging the trigger. The condition may occur, regardless of the manual thumb safety position if equipped. This may also result in multiple discharges.

2, With a loaded magazine in the firearm, the grip safety depressed, manual safety in the fire position, slide closed, and a round in the chamber, pulling the trigger will cause the round to fire normally, however as the slide cycles, the next round may be ignited as it is chambered by the hammer failing to fully engage the sear, causing multiple discharges.

Stop using your M&P® Shield™ EZ pistol until you determine whether it is included in this safety recall, and if so, until it has been inspected and repaired by Smith & Wesson, if necessary.


HOW TO LOCATE YOUR SERIAL NUMBER AND DATE OF MANUFACTURE:

Image



*Moar at link
The Horde has left these parts and shambled over to www.ufozs.com



Image ............................................................................................................................................................................................Image

Post Reply