I was wondering if anyone had a glock that has been milled for a rmr or has done the work that has the spec for the cut depth and length. I have a general idea of where to start for the rear sight and how deep to go but I'm not sure.
Thanks
Leland
Glock rmr milling
Moderator: ZS Global Moderators
- Makarov
- ZS Lifetime Member
- Posts: 2354
- Joined: Tue Jan 03, 2006 2:21 pm
- Favorite Zombie Movies: Shaun of the Dead
The Walking Dead - Location: Trondheim, Norway
- Contact:
Re: Glock rmr milling
I was looking into this (though I've found a guy that can do it here in Norway) as I want to build up a G17. There's information out there, this guy's video(s) about milling a slide gives a lot of info.
Thomas
Der skal Kugle til en Thrønder
RIP hk33k
Der skal Kugle til en Thrønder
RIP hk33k
Re: Glock rmr milling
Thanks man that was really helpful. guess its time to buy a cheap police trade in to try it on.
Thanks
Leland
Thanks
Leland
- Makarov
- ZS Lifetime Member
- Posts: 2354
- Joined: Tue Jan 03, 2006 2:21 pm
- Favorite Zombie Movies: Shaun of the Dead
The Walking Dead - Location: Trondheim, Norway
- Contact:
Re: Glock rmr milling
No problem.lel40k3 wrote:Thanks man that was really helpful. guess its time to buy a cheap police trade in to try it on.
Thanks
Leland
As of now I've got a slide and a RMR waiting to get together in a happy communion. Think I need to get things going with that guy I've found...
Thomas
Der skal Kugle til en Thrønder
RIP hk33k
Der skal Kugle til en Thrønder
RIP hk33k